1、Thermal stability of hybrid material was analyzed by DSC and TG.
示差掃描量熱法(DSC)、熱重法(TG)測試分析了材料的熱穩定性。

2、Multiple melting behavior of Nylon 1010 has been investigated by using DSC instrument.
本文用差示掃描量熱法(dsc)研究了尼龍1010的多重熔化行為。

3、PURITY DETERMINATION OF CHEMICALS & PHARMACEUTICALS BY DSC METHOD
差熱分析法測定化工品、藥品純度

4、Determination of Purity of Inositol by DSC Method
差示掃描量熱法測定肌醇純度

5、Ageing of the asphalt coating was analysed with IR, DSC and TG.
結合紅外(IR)、差熱分析(DSC)、熱失重(TG)測試手段分析石油瀝青涂層的老化程度。

6、DSC STUDY ON MUNG BEAN STARCH
綠豆淀粉的DSC研究

7、INVESTIGATION ON PAS AND DSC OF RAREEARTHS Ni-P ALLOY
稀土鎳磷非晶合金的PAS和DSC研究

8、It was characterized by optical microscope, SEM, IR, DSC and X-rays diffractometer respectively.
采用光學顯微鏡、SEM、IR、DSC和X射線衍射等多種手段對其進行表征。

9、DSC curves are solved with computer by non-linear fitting method.
DS C曲線用非線性擬合法在計算機上求解。

10、DSC for Graft Copolymer PP-g-MAH and Study on Its Adhesive Property
接枝共聚物PP-g-MAH的差熱分析及粘接性能的研究

11、The IPN structure was proved by solubility test, DSC and TEM.
通過溶解性能，熱分析及電鏡，表征了IPN結構的存在。

12、A Study on the Compatibility of PET/PEG Blend with DSC Method
用差示掃描量熱法研究 PET/PEG 共混物的相容性

13、DSC permits obtaining softening response by using hardening model.
擾動狀態理論允許利用硬化模型得到軟化響應。

14、DSC EXPERIMENTAL ANALYSIS ON THE MATURATIONS OF KEROGEN EVOLUTION
干酪根演化程度的DSC實驗研究

15、Study on the Latent Curing System of Epoxy Resin with DSC Method
以DSC法研究環氧樹脂的潛伏固化體系

16、Melting of BOPP and IPP was studied by means of DSC in this paper.
本文采用差示掃描量熱法(DSC)研究了雙向拉伸聚丙烯膜(BOPP)和吹塑聚丙烯膜(IPP)的熔化過程.

17、Their properties are characterized by DSC and polarizing microscopy.
用差熱掃描量熱儀和偏光顯微鏡檢測其液晶性。

18、The combined standard uncertainty of HPLC is 0.454%, and DSC is 0.025%.
差示掃描量熱法檢測N-苯基-β-萘胺純度合成標準不確定度為0.025%。

19、The purity tested by DSC is 99.20% with RSD of 0.05%.
DSC檢測樣品純度為99.20%,RSD為0.05%。

20、The cured process and principle of polyurethane powder paint were studied by DSC method.
運用DSC方法研究了聚氨酯粉末涂料固化時的基本過程及原理。

21、Study on Thermal Stability of A Shape Memory Alloy By DSC Method
用DSC法研究形狀記憶合金的熱穩定性

22、DSC STUDY OF Na_2SO_4·10H_2O-NaCI THERMAL ENERGY STORAGE SYSTEM
Na_2SO_4·10H_2O-NaCl貯熱體系的DSC研究

23、Computerization of DSC Quantitative Determination
DSC定量的電子計算機化

24、The DSC transceiver connector is trouble.
數字選呼收發機連接器故障。

25、Complicated DSC curves can be analyzed with incomplete cycle method.
復雜DS C曲線可用不完全循環法分析。

26、CHARCTERISTICS OF DSC CURVES IN Ti-Ni SHAPE MEMORY ALLOYS
Ti-Ni形狀記憶合金DSC曲線的特征

27、The double melting peaks of reaction products detected by, DSC are explained.
對反應產物熱分析過程中出現的雙熔融峰作了解釋。

28、The melt act of PBT is studied by DSC measurement.
同時還用DSC法分析了所合成PBT的熔融行為。

29、DSC of the Epoxy Cure Reaction
用DSC研究環氧樹脂的固化反應

30、DSC ANALYSIS OF DOMESTIC ASPHALT
國產瀝青的DSC分析

DSC翻譯